FBE Coated ERW Steel Pipe

FBE coating pipe is Fusion Bonded Epoxy coating steel pipe. It is an externally applied heat resin for pipe. With a form of dry powder at thickness 300-600 microns on to the heated surface of pipe. Once the FBE coated on the pipe surface, the FBE film provides an extremely hard surface with great adhesion to the pipe surface. The FBE layer in a even form and have good resistance to the chemical reaction.

Advantage of the FBE coating pipe:

1.      Convenient to spraying, no pollution, excellent resistance for high temperature (-40°C to 85°C)

2.      High strength and anti-bending performances;

3.      Strong adhesion, good integrity, anti soil stress and wear.

4.      The pipe can be very highly polished, very healthy and environmental and it has passed the test for Disease control and Prevention.

5.      Good anticorrosive property, its service life can be more than 100 years.

6.      It can well prevent the growth of bacteria and mounds in the water have a high anti-scale building up ability. There have the possibility of blocking the pipe ends, if the water     capacity is so bid when the cement lining is used.

7.      It delivers mor 15-20% volume of water compared with the same diameter other type coating pipes (cement lining )

FBE coated steel pipe usually buried in soil and under water between -40°C~85°C temperature.

On the other hand, the defect of the FBE pipe is it doesn’t have good resistance to mechanical performances and humid conditions.

Our FBE coating perform the standards as per SY/T0315, CAN/CSA Z245.20, AWWA C213, Q/CNPC38 etc.

Use: Widely used in land, underwater pipeline anticorrosion.

Standard comply with – AWWA C213

Thickness

The coating power shall be applied to the preheated pipe at a uniform cured – film thickness of not less than 12 mils (350 μm) on the exterior and interior. The maximum thickness shall not exceed an nominal 16 mils (406 μm) unless recommended by the manufacture of specified by the purchaser.

Advantage

Interior and exterior FBE introduction

The FBE coating is very good for conveying drinking water as well as oil and gas transmission which is specially used for water drinking and water distribution system in the international market, fusion bonded epoxy coatings are het- activated, chemically cured coating systems